GE KTD-400, Руководство пользователя

Страница: 11 / 28

7
3. The clear memory option ( Figure 10 ) will
erase all data in the controller keypad’s
nonvolatile memory and reload the factory
default values.
• If you do not want to clear the memory,
press
0 . This will advance you to the
system size display ( Figure 11 ).
• To clear the controller keypad’s memory,
press
1 . This will advance you to the
confirmation display. Press 3 to reload
the controller keypad’s memory with
factory default values. If you do not
want to clear the memory, press
0 . This
will advance you to the system size
display (
Figure 11 ).
Figure 10. Clear memory display
4. At the system size display ( Figure 11 ), use
the numerical keys to enter the largest
camera number (maximum 511), largest
monitor number (maximum 64), largest
multiplexer number (maximum 64), and
largest VCR number (maximum 64) in the
system. Use the left and right arrow keys to
switch between columns. Once you have
made all entries, the display will advance to
the next menu.
Note: Multiplexer and VCR entries can be 00,
which means there are no units in the
system (display will skip subsequent
menus).
Figure 11. System size display
5. The camera site access display ( Figure 12 )
lets you deny or permit the controller keypad
access to certain camera sites. Press
0 to
deny access or 1 to permit access. After each
selection, the next camera number will
appear. Use the up and down arrow keys to
move between cameras. When done, press
Seq to advance to the next menu.
Note: In steps 6 through 8, Seq will not advance
to the next menu if you deny access to all
cameras, monitors, and VCRs. At least one
camera site, monitor, multiplexer, or VCR
must have access.
Figure 12. Camera site access display
CLEAR MEMORY?
0=NO 1=YES SEQ=EXIT
ARE YOU SURE?
0=NO 3=YES SEQ=EXIT
SYST SIZE (CAMERAS)
511 64 64 64 SEQ=NEXT
CAMERA 000 ACC=YES
0=NO 1=YES SEQ=NEXT