Evolution Series E9000 User Manual
20
Pilot Bracket and Door
The pilot device door can be removed by lifting straight
off per Figure 33. Also, the metal bracket can be removed
by loosening mounting screws and removing bracket.
Figure 33. Grasp the center of the door
Figure 34. Pilot device bracket locking bracket in door
The pilot device bracket in is locked in place using the
door mounted locking bracket shown in Figure 34.
All pilot device brackets for Arc Resistant MCCs are
metallic (both standard and AFM units). Standard
E9000 MCCs utilize a plastic pilot device bracket.
Figure 34A. Arc Resistant metallic pilot device bracket
NEMA 3R Outdoor Enclosure Installation
NEMA 3R Installation Instructions
1. Remove left rear cover on right shipping module (Figure 1.) Save
the screws for later reassembly of the cover. Note that the left
module right rear cover has a flange that will be underneath the
removed covered with it is replaced. This provides an overlapping
connection in the rear of the two spliced modules (Detail C).
2. Slide adjoining shipping modules as close together as possible
while carefully aligning the modules front-to-back.
3. Join shipping modules together using (4 sets) 1/2 hardware
(front only). Hardware kits shipping with modules.
4. Assemble bus splices per splice instructions (included in splice
kit).
5. Install wireway transition channel barrier by sliding it though
the 5 x 5 wireway cutout and attaching it using (1) 1/4-28 x 3/8
thread rolling (Figure 3).
6. Re-attach right, rear cover by re-attaching 1/4-20 x 5/8 sealing
screw (Detail C).
7. Attached center cap using (8) 1/4-20 x 5/8 thread rolling screws
(Figure 1).
Notes:
1. 3-inch floor members can be installed similarly to standard
MCC flor members.
2. Module doors can be removed by removing 1/4-20 x 3/8 thread
rolling screws from door hinge bracket (Detail D).
