GE Druck PACE1000, Инструкции по безопасности и руководство пользователя

Страница: 15 / 148

[EN] English 14 K0467 Revision A
Table 1 RS232 Connections
6.2 Handshaking connections
Software handshaking use: TXD, RXD and GND.
Hardware handshaking use: TXD, RXD, GND, CTS, RTS and DTR.
6.3 IEEE 488 Interface
The interface complies with IEEE 488 standard.
The IEEE 488 parallel interface connects a computer/controller to one or more PACE1000
instruments and other instruments.
Up to 30 instruments can be connected through a high-speed data bus to the computer/
controller.
Note: The length of each IEEE 488 cable must be less than 3 metres to comply with the EMC
requirements (Ref: Data sheet).
6.4 Single Unit Installation (Figure 8)
1. Connect an IEEE 488 connector/cable assembly to the rear panel of the instrument.
2. Connect the other end of the connector/cable assembly to the IEEE 488 connector on
the controller/computer.
3. Change the IEEE 488 communication parameters (Ref: K0470, User manual, Supervisor
set-up, section 6.7).
Instrument Control Line Computer/Printer
Instrument
Function
Connector
9-way
D-type
Pin No.
Signal
Direction
RS232
Terminology
Connector Type
9-way
D-type
Pin No.
25-way
D-type
Pin No.
RxD (I/P) 3  TxD 3 2
TxD (O/P) 2  RxD 2 3
GND 5  GND 5 7
CTS (I/P) 7  RTS 7 4
RTS (O/P) 8  CTS 8 5
Pulled
high
internally
1

RLSD
(DCD)
1 8
Not
connected
4

DTR 4 20
Pulled
high
internally
6 
DSR
DCE Ready
6 6
Equipment
chassis
Connector
shell
 Cable Screen - 1