GE CS5500, Руководство по программированию

Страница: 69 / 84

Term Definition
Phone Line Cut A menu option that sends a report is sent to the central station the moment the
phone line cut is restored. If a CS7001 GSM module is installed, it may be
configured to report the phone line cut straight away. (System Reports)
A menu entry that groups options that activate the internal siren when a phone line
is cut while armed or disarmed. (Internal Siren>Sounds On)
A menu entry that groups options that activate the keypad buzzer when a phone
line is cut while armed or disarmed. (Keypads>Sound On)
A menu entry that groups the report codes sent when a phone line is cut. (Report
Codes)
Phone Line Cut Delay A menu option that sets the length of time before a phone line cut is signalled after
a phone line cut is detected.
Phone Number A menu option that specifies the phone number of the central station where events
are reported. The control panel can report to up to six phone numbers.
Phone Numbers A menu entry that groups phone number reporting options.
Phone Prefix A menu option that specifics the phone prefix. This is a four-digit telephone prefix
that is used to select tone and pulse dialing and enter a delay to wait for a dial
tone. This sequence is pre-dialled by each of the telephone numbers.
#1 programs a *.
#2 programs a #.
#3 programs a four-second delay at any point in the prefix (displayed as a
comma).
#4 switches to pulse dialling (displayed as P). Tone dialling is the default.
If a four-second delay is programmed at the first digit, the panel does not wait for a
dial tone before starting to dial the number. Select this option when the phone
system has a poor quality dial tone or does not generate a dial tone.
PIR Passive infrared motion sensor.
Playback A menu entry that groups options that allow the installer to play back recorded
voice messages.
Power A menu entry that groups the power events that are reported to the selected
phone number. (Phone Numbers)
A menu entry that groups the power events that are reported to the central
station. (System Reports)
A menu entry that groups report codes that are sent to the central station when
power related events occur. (Report Codes)
A menu entry that groups the timer options relating to power events. (Timers)
Power Failure A menu option that sends a message to the central station when power failure
occurs. This is a CS7001 GSM module option.
Power light An LED light indicating that the system is connected to the mains power. The
power light is on when the mains power is on. The power light flashes when the
system has a low battery condition.
Power Modules See CS320 Power Modules
Power Trouble and
Restores A menu option that reports mains failure, mains restore, low battery and low
battery restore events to the selected phone number. (Phone Numbers)
A menu option that sends power trouble and restore reports to the central station
depending on the condition of the panel dialler. (CS7001 GSM Module)
See also
Panel Dialler OK Events and Panel Dialler Not OK Events
Power Up Delay A menu option that sets the time between mains restore after a power failure and
the system powering up again. This can be set from 0-60 seconds. 0 means no
power up delay.
Pre-dial Delay See Dialler Delay
Prog Outputs A menu entry that groups options that configure outputs.
Program Data Command A menu command request sent by the home automation system to the CS586
Direct Connect module. It is used to configure the system through the serial port.
Program Data Request A menu command request sent by the home automation system to the CS586
Direct Connect module. It is used to read configuration data from the control panel
through the serial port.