GE CL 5, Руководство по эксплуатации

Страница: 34 / 93

3-6Issue 01, 04/05 CL 5
3.2 Configuring the Instrument
Prior to using the CL 5 to measure thickness, some or
all of the following parameters must be specified using
the Configuration display shown in Figure 3-3.
• Language – Set the displayed language to English,
German, French, Spanish, Italian, etc.
• Units – Set the unit of measurement to inches or
millimeters
• Resolution – Sets the number of decimal places to
which thickness measurements are displayed
• Update Rate – Update the displayed measurement
at a rate of 4 or 8 Hz
• Radix – Select a period (.) or comma (,) to be used
as a decimal point
• Battery Type – Select from Alkaline, NiCAD, or NiMH
• Auto Power Down – Select ON to automatically turn
the instrument off five minutes after the last key
press (no data will be lost) or OFF to allow the
instrument to remain on until manually powered off.
• Contrast – Adjusts the display contrast
• Backlight – Adjusts the display lighting (a setting of
ON increases battery usage, a setting of AUTO
causes backlighting to illuminate and remain on for
Five Seconds after each key press.)
Each of these parameters is set the same way:
Step 1: Press multiple times to access the display
(shown in Figure 3-3).
Step 2: Press or to select each parameter you
would like to modify.
Step 3: When the desired parameter is highlighted,
press to activate it.
Setting Up the CL 5
Configuring the Instrument‘s Display
3-6Issue 01, 04/05 CL 5
3.2 Configuring the Instrument
Prior to using the CL 5 to measure thickness, some or
all of the following parameters must be specified using
the Configuration display shown in Figure 3-3.
• Language – Set the displayed language to English,
German, French, Spanish, Italian, etc.
• Units – Set the unit of measurement to inches or
millimeters
• Resolution – Sets the number of decimal places to
which thickness measurements are displayed
• Update Rate – Update the displayed measurement
at a rate of 4 or 8 Hz
• Radix – Select a period (.) or comma (,) to be used
as a decimal point
• Battery Type – Select from Alkaline, NiCAD, or NiMH
• Auto Power Down – Select ON to automatically turn
the instrument off five minutes after the last key
press (no data will be lost) or OFF to allow the
instrument to remain on until manually powered off.
• Contrast – Adjusts the display contrast
• Backlight – Adjusts the display lighting (a setting of
ON increases battery usage, a setting of AUTO
causes backlighting to illuminate and remain on for
Five Seconds after each key press.)
Each of these parameters is set the same way:
Step 1: Press multiple times to access the display
(shown in Figure 3-3).
Step 2: Press or to select each parameter you
would like to modify.
Step 3: When the desired parameter is highlighted,
press to activate it.
Setting Up the CL 5
Configuring the Instrument‘s Display