GE Appliances C2S985, Техническое обслуживание руководство

Страница: 32 / 76

– 32 –
4. Remove the four T-15 Torx screws (2 not shown)
holding the front of the cooktop to the control
panel.
5. Remove the three 1/4-in. hex-head screws and
the vent trim.
6. Remove the two 1/4-in. hex-head screws from
the rear of the cooktop and remove the cooktop
from the range.
To remove the cooktop (Profi le and GE models):
1. Remove the surface burner igniters and the
screws holding the burners to the cooktop. (See
To remove the cooktop (Café models)
, steps 1–3.)
2. Insert a putty knife between the cooktop and
manifold panel 2 inches from either side.
3. Lift the cover as you push in each release clip.
4. Lift the front of the cooktop panel upward
approximately 45 degrees.
5. Lower the rear of the cooktop panel to
disengage the hinge slots from the hinge pins.
6. Lift the cooktop panel up and over the hinge
pins and remove the cooktop panel.
Note: Range shown with control panel removed for
clarity.
Note: The cooktop panel hinge slots rest on a hinge
pin mounted to each end plate.
Vent Trim
Hinge Slot
Hinge Pin