GE Security NX-592E, Руководство по установке, Страница: 13 / 20

11
While in programming mode and not in a location, the number in parentheses is the location you were
previously changing. For example, if the display reads “Enter location, then # (2)”, it is reminding you that
location 2 was the last location you programmed.
Location 0 programming the LCD keypad address
Certain commands in the NX-592E require it to know the location of at least 1 LCD keypad (if one exists in the
system). If your system has an LCD keypad we recommend that you place in partition 1 keypad 1. This will
allow location 0 to be left at the factory default. If the LCD keypad is selected as something other than partition
1 keypad 1, program the appropriate address in location 0. Select the address from the following chart.
Status LEDs
The status LEDs indicate the module’s current signal and status. The bottom red REG LED indicates the
module is registered and in range. The yellow ACK and green XMT LEDs indicate the module’s message
status. The top red ERR LED indicates proper communication between the main board of the NX-592E and the
wireless modem. See
Table 5 on page 12 for a complete list of LED condition patterns.
The red REG LED remains:
• On - when the module is registered and in range.
• Off - when the module is out of range and not registered with the network.
• Flashing - when the module is registered but out of range.
The yellow ACK LED remains:
• On - after the first message has been sent to and received by Alarm.com services.
• Off - until a message has been sent by the module.
• Flashing - while the first message is being sent by the module.
Table 4. Addresses
Keypad Part 1 Part 2 Part 3 Part 4 Part 5 Part 6 Part 7 Part 8
1 192 193 194 195 196 197 198 199
2 200 201 202 203 204 205 206 207
3 208 209 210 211 212 213 214 215
4 216 217 218 219 220 221 222 223
5 224 225 226 227 228 229 230 231
6 232 233 234 235 236 237 238 239
7 240 241 242 243 244 245 246 247
8 248 249 250 251 252 253 254 255