GE Security NetworkX NX-1300E, Руководство пользователя

Страница: 21 / 24

Page 19
Beeps during an exit delay; beeps rapidly for the last 10 seconds of an
exit delay; and beeps 1 second at the end of the exit delay.
Pulses when the armed status changes and the AC power is off.
Pulses when the armed status changes and any zone(s) are bypassed.
Pulses when the armed status changes and a low battery is detected.
Pulses when the armed status changes and a Tamper condition is
detected.
Beeps to indicate Telephone Line Cut, if selected.
Pulses when one or more of the following conditions are detected: Zone
or Box Tamper, Low Battery, AC Power Fail, or Expander trouble.
Entering a valid code will silence the keypad sounder when it is pulsing. The
arm/disarm state of your system will not change when entering a code to
silence a pulsing keypad sounder. Please contact your installer if a trouble
condition exists.
EMERGENCY EVACUATION PLANS
An emergency evacuation plan should be established for an actual fire alarm
condition. For example, the following steps are recommended by the National
Fire Protection Association and can be used as a guide in establishing an
evacuation plan for your building.
Draw up a floor plan of your home. Show windows, doors, stairs, and
rooftops that can be used for escape. Indicate each occupant's escape routes.
Always keep these routes free from obstruction. Determine two means of
escape from each room. One will be the normal exit from the building. The
other may be a window that opens easily. An escape ladder may have to be
located near the window if there is a long drop to the ground below. Set a
meeting place outdoors for a headcount of the building occupants.
Practice escape procedures. In a home, sleep with bedroom door closed; this
will increase your escape time. If you suspect fire, test the door for heat. If
you think it is safe, brace your shoulder against the door and open it
cautiously. Be ready to slam the door if smoke or heat rush in. Practice
escaping to the outdoors and meeting in an assigned spot. Call the Fire
Department from a neighbor's phone. NOTE : After the installation of your
Security System has been completed, notify your local Fire and Police
Departments to give them your name and address for their records. Early
warning fire detection is best achieved by the installation of fire detection
equipment in all rooms. This equipment should be installed in accordance
with the National Fire Protection Association's Standard 72. For additional
information write the National Fire Protection Association, Batterymarch Park,