Ge Est QS4, Техническое справочное руководство

Страница: 135 / 138

SIGA-REL programming
QS4 Technical Reference Manual C.5
¨ ¨ ¨ ¨ Create a response that activates
the prerelease circuits when any
one detector in the protected
area signals an alarm 1. Click Configure > Correlations
2. Click the Zones tab, then click Add Zones.
3. Click the Members tab, then click Add Device.
4. Select only the devices required to activate the SIGA–REL
prerelease circuits then click OK.
5. Click the Responses tab, click the Response Type arrow,
and then select Active.
6. Click Outputs, select the device labeled SIGA REL1 A005
PRERELEASE 1&2, and then click OK.
¨ ¨ ¨ ¨
Create a response that activates
the release circuits when two or
more detectors in the protected
area signal an alarm
Note: To comply with NFPA 72, you
must program an And Group with at
least two smoke detectors and a
minimum activation count of 2. The
smoke detectors must have their
Primary and Alternate Verification
properties set to None (verified smoke
detectors not allowed).
1. Click the And Groups tab, then click Add AND Group.
2. Set the Activation Count box for 2.
3. Click the Members tab, then click Add Device.
4. Select only the detectors required to activate the SIGA–
REL release circuits then click OK.
5. Click the Responses tab, click the Response Type arrow,
and then select Active.
6. Click Delays
7. In the Delay On list, click Activation and Restoration.
8. Set the Seconds box to 10.
9. Click Outputs, select the device labeled SIGA REL1 A003
RELEASE 1&2, and then click OK.
¨
¨ ¨
¨
Create a response that activates
the release circuits when someone
presses the manual release switch
1. Click the Devices tab, then select the circuit labeled
SIGA–REL A002 MAN RELEASE SW.
2. Click the Responses tab, click the Response Type arrow,
and then select Active.
3. Click Outputs, then:
Hold the Ctrl key down
Select the device labeled SIGA REL1 A005 Prerelease
1&2
Select the device labeled SIGA REL1 A003 Release 1&2
Release the Ctrl key then click OK.
Note: The prerelease circuit must appear before the releasing
circuit in the response list.
Technical Manuals Online! - http://www.tech-man.com