GE Consumer & Industrial ZIC360NR, Техническое обслуживание руководство

Страница: 38 / 51

– 38 –
P0003343
Defrost Overtemperature Thermostat
Evaporator Thermistor
Drier
The drier is positioned vertically in the center of the
machine compartment. A copper process tube,
connected to the inlet of the drier, provides access
to the high-pressure side of the refrigeration
system. The capillary is connected to the outlet of
the drier.
Evaporator
The evaporator is made of copper and aluminum
and is located above the evaporator fan at the top
of the freezer compartment.
To replace the evaporator
1. Recover the refrigerant.
2. Remove the evaporator fan (see procedure).
3. Remove the defrost heater (see procedure).
4. Remove the defrost overtemperature
thermodisc and evaporator thermistor.
5. Disconnect the ground wire from the
evaporator and position all wiring to allow for
evaporator removal.
6. Remove the screws securing the evaporator to
the cabinet.
Caution: Protect wiring from heat during
desoldering and resoldering.
7. Desolder the capillary tube from the
evaporator.
8. Desolder the suction line.
9. Remove the evaporator.
10. Using a file, score the capillary tube just above
the old solder and break the solder-covered
section off. This will help prevent the capillary
tube from becoming plugged when resoldering.
11. Position the new evaporator in the cabinet.
Insert the suction line and capillary tube into
the evaporator.
12. Solder the suction line to the evaporator.
13. Solder the capillary tube to the evaporator.
14. Install a replacement drier WR86X93.
15. Evacuate and recharge the system using
currently accepted procedures.
Note: Mastic should be replaced on evaporator
discharge line after replacing the evaporator.
Shown with Inverter Removed
Drier