DU-LC-0002-60 Rev C 6/14/06 GCX Corp. Page 11 of 11
Tilt Tension Screws (2)
Tilt Lever
8.0 Cable Management
One (1) Cable Clip (below left) is provided for managing
cables along Roll Stand Post. Place loose cables inside Clip
and slide Clip onto Post (below right).
9.0 Adjusting Tilt and Tilt Tension
Adjust tilt
by loosening the Tilt Adjustment Lever (see
Note
below). Grasp
the device and tilt to desired angle. Tighten Tilt Adjustment Lever to lock
position.
Adjust tilt tension
by equally tightening or loosening two (2) Tilt Tension
Screws with the 9/64'' hex wrench provided. Once overall tilt tension is set,
use Tilt Adjustment Lever to fine tune/lock tilt position.
10.0 Periodic Maintenance & Cleaning
All fasteners associated with the mounting system should be inspected periodically and tightened as necessary.
Cleaning the Mounting Assembly
CAUTION:
GCX makes no claims regarding the efficacy of the listed chemicals or processes as a means for controlling
infection. Consult your hospital’s infection control officer or epidemiologist. To clean or sterilize mounted devices or
accessory equipment, refer to the specific instructions delivered with those products.
1. The mounting assembly may be cleaned with most mild, non-abrasive solutions commonly used in the hospital
environment (e.g. diluted bleach, ammonia, or alcohol solutions).
2. The surface finish will be permanently damaged by strong chemicals and solvents such as acetone or
trichloroethylene.
3. Steel wool or other abrasive material should never be used.
4. Damage caused by the use of unapproved substances or processes will not be warranted. It is recommended that you
test any cleaning solution on a small area of the mounting assembly that is not visible to verify compatibility.
5. Never submerge or allow liquids to enter the mounting assembly. Wipe any cleaning agents off the mounting assembly
immediately, using a water-dampened cloth. Dry all parts thoroughly after cleaning.
Cable Clip
Roll Stand Cable Clip
Cables
Slide onto Post
Note:
The Tilt Adjustment Lever is a multi-
position clamping lever that operates by
lifting, rotating, and releasing the handle.