gbo TESI Relax, Руководство пользователя, Страница: 18 / 32

18 TESI Relax
gbo Medizintechnik AG Version 2.1
4 Therapy
4.1 Thermotherapy
For thermotherapy the cover of the middle section of the TESI Relax table can be heated. If required the
thermotherapy can be combined with all other therapies.
By touching the Button (+) or Button (
-
) on the Touch Screen the temperature of the cover of the middle
section of the TESI Relax table can either be increased up to a maximum heating capacity of 35°C or
reduced.
4.2 Massage
Through casters which pass the vertebral column with adjustable pressure it is possible to apply a
paravertebral roller massage with in-depth muscular effect. The height of the massage rollers is adjustable. If
required the massage can be supported by an additional and separately connectable vibration.
The massage is independent of the thermotherapy and extension treatment but can be combined with them if
required.
1. By touching the
Buttons (+,
-
)
you set:
Temperature (if thermotherapy is required),
Raise of step.
2. Touch the
Button
for massage. The roller pressure will be set on 50%.
3. Touch the
Buttons (+,
-
)
to set the treatment time.
4. Touch the Buttons (+,
-
) to set the roller pressure.
5. Touch the
Buttons (<,>)
to set the region of the back.
6. Touch the Buttons (+,
-
) to set the speed, the massage starts! The treatment time does not pass yet (see
Point 8).
7. If required, set the vibration by touching the Buttons (+,
-
) .
8. Touch the
Start-Button
. The treatment time passes.
9. At the end of the treatment time the triad-gong sounds. The massage rollers go down and stop.
Vibration stops.
10. After the treatment the patient should remain in an upright position with his legs dangling over the side
of the table for about 3 to 5 minutes and remain quiet and relaxed.
11. If the table is not used any longer, press the
Standby-push-button
.
!!
Note!
The treatment can be stopped at any time by touching the
Button (Stop)
.
The treatment can be stopped at any time by pressing the
Interruption switch
.
10 minutes after the end of the treatment the device will automatically activate the standby-mode,
consequently the stepped bed will move down.This setting can be modified
(see Chapter 2.3.2).