TESI
Relax
15
gbo Medizintechnik AG
Version 2.1
3
Description of function
3.1
Standby-push-button
The
standby-push-button
is placed on the right side below the Touch Screen. If the device is in standby-
mode,
the standby-push-button
is shining.
You can put the table in standby-mode by pressing
the standby-push-button
. The stepped bed will lower
down and all functions of the table are switched off. By pressing the
standby-push-button
again, the normal
functions of the table will be reactivated.
10 minutes after the end of the treatment the device will automatically activate the stand-by-mode, which
means that the stepped bed will move down. This setting can be modified
(see chapter 2.5.2).
3.2
Optical and acoustic user guidance
Optical user guidance:
Optical user guidance is effected on the
Touch Screen.
The setting, which is changed at the moment, is
displayed in
green.
Acoustic user guidance:
The following table shows the acoustic signals and the relating meaning:
Type of signal
Reason
Information sound
In case of a failure;
Triad gong
At the end of the faultless automatic check when switching on
the device;
At the end of the treatment time.
Table 3:
Acoustic user guidance
3.3
Remote control
The remote control is an infrared remote control with plastic foil keyboard. By the remote control the patient
is able to change the settings at anytime before and especially during the treatment. The cuurrent meaning of
the buttons are displayed on the Touch Screen (see Figure 2).
By touching the
Buttons
(<,>)
setting/function can be selected.
By touching the
Buttons (+,
–)
the value of setting/function can be changed.
By touching the
Button (OK)
you confirm your choice.
If you want to change the batteries:
1.
Open the remote control by unscrewing the cross-head screw on the backside of the remote control.
2.
Open the cover-plate carefully. Please pay attention to the connecting cables between the cover-plate
and the backside of the remote control.
3.
Remove the holding-clamp for the batteries by dismantling the screw.
4.
Replace the old batteries with two new micro-batteries.
5.
Fix the holding-clamp.
