GBC Spire III 44T, Инструкция по эксплуатации

Страница: 23 / 49

SPIRE III Series
– Installation and Operating Instructions
Page 5-8
3. Raise it until it is above the Front Main Roller.
Figure 23. Feed Table in Raised Position.
4. Secure the Feed Table with an Upper Front
Rewind Shaft Clevis Pin.
Figure 24. Clevis Pin Securing the Table.
Ir s
ensor
Figure 25. IR Sensor Behind the Top Main Roller.
Depending on the laminator, IR Sensors read the
temperature of the heated Main Rollers to ensure
proper temperature. The Top Main Roller (44T, 64T,
64Ct) IR Sensor is located behind the Main Roller.
The Bottom Main Roller (44T, 64T) IR Sensor (not
shown) is located behind the Bottom Main Roller.
c
learInG a
B
locked
Ir s
ensor
If the IR Sensor becomes blocked, an alarm sounds
and the display on the Control Panel flashes. The
obstruction must be cleared before continuing
operation. Refer to the “Clear a Film Jam (Wrap-Up)”
section.
WARNING: Hot rollers could burn you. Keep
fingers and hands away from the hot rollers.