GBC Spire III 44T, Инструкция по эксплуатации

Страница: 34 / 49

Page 6-7
SPIRE III Series
– Installation and Operating Instructions
8. Carefully grab the web (top and bottom film),
from the front operating position and pull
towards you.
REWINDER
PSA LAMINATE
IDLER
IDLER
MAIN
ROLLER
MAIN
ROLLER
PULL
ROLLER
PULL
ROLLER
Printed Media or Mount Adhesive
PULL WEB
Figure 47. Pulling remaining web from the laminator
diagram.
9. Do not allow the adhesive side of the film to
contact the Main or Pull Rollers.
c
lear a
F
Ilm
J
am
(W
rap
-u
p
)
Film jams (wrap-ups) may occur if the film is loaded
backwards or if the area at which film exits the
equipment is blocked. The film can wrap around the
Main or Pull Rollers during webbing if a threading
card is not used.
To clear a jam (wrap-up):
1. Immediately stop the laminator by pressing
STOP .
2. Press and hold REV while pulling on the web.
3. Manually guide the web out of the Main and Pull
Rollers.
WARNING:
Rollers may be hot. Hot rollers
could burn you. Keep fingers and hands away from
the hot rollers.
4. Once the film jam has been cleared, re-thread
the film web. Refer to the “Webbing the Machine”
section.