GBC FusionPunch II, Руководство по обслуживанию

Страница: 315 / 430

Host Machine Enablement (DT135 / 4XXX)
GBC FusionPunch II Service Manual
12/2003
6-43
Host Machine Enablement (DT135 / 4XXX)
DocuTech 135 Host M achine Enablement
1. Open
the Job manager.
2. Log in with your user ID and password.
3. Go to the top right corner of the keyboard and press Diagnostics.
NOTE: If you have a job in the printer queue, the DocuTech will prompt you
to switch immediately.
4. Press yes.
5. After Diagnostics have been invoked, select DC C ontroller, found in
the top left corner of the screen.
6. Go to Controller dC105 and enable BYPASS TRANSPORT by
selecting “other”.
7. On the next screen, select DC 131 NVM Read and Write.
8. Select FBN and enter the values for the specified F BN nodes, as listed
below.
FBN settings for DocuTech 135
• FBN 186 = 0: This is the End of Set Offset Time
•
FBN 188 = 100: This is the End of Set Pulse Width
•
FBN 191 = 0: This is the lead edge and trail edge trigger
• Lead edge = 0 and Trail edge = 1
After you have entered the values, you must close the call. To do this:
1. Select SCP, found in the top left corner of the screen.
2. Go to the bottom left corner of the screen and click Close Call.
NOTE: The DocuTech will prompt you to enter service call information.
3. Enter Other for the cause of call.
4. Enter Incomplete Other for the status of call.
5. Go to the bottom right corner of the screen and click Close Call.
6. Click Yes to close call.
Click the Printer icon and then Reset. The End of Set signal will be timed
correctly with the Fusion Punch and the Offset stacker.
Xerox 4xxx LPS Host Machine Enablement
1. Stop any job that is currently running and take the system offline.
2. Log in at the
log4
level. Type
log 4
and press
Enter.
3. Type
Field Engineer
and press
Enter
.
4. Type edit and press Enter .
The prompt,
EDIT>
displays.
5. Type
INS 10,10
and press
Enter
.
A line number will display, for example, 000010 .
6. Type
CLEAR = OUT135,0,0,0,0,0,0,0,0,0,0,0;
and press
Enter
.
The next line number will display, for example,
000020
.
7. Type GBCPUNCH = OUT135,0,0,0,0,0,0,7,0,0,0,0; and press
Enter
twice. The
EDIT>
prompt displays again.
8. Type
SCE
and press
Enter
.
The system will prompt you to name the file so it can save it.
9. Type
FCG.LIB
and press
Enter
.
10. If the system asks you to overwrite the file, press
Y
for yes.
The system will save the GBC Punch Profile to the printer.
You must now load the profile. Use the following procedure to load
the profile.
1. Press
Enter
to exit the EDIT> mode.
2. Type
FCG GBCPUNCH
and press
Enter
.
NOTE: There is a space between
FCG
and
GBCPUNCH
.
The system will display a message indicating that the profile has
successfully loaded. This completes the profile setup.
3. Instruct the customer to send all punch jobs to Stacker bin E .
This will route all punch jobs to the bypass transport and finisher with
the correct timing and profile values.