GBC FusionPunch II, Руководство по обслуживанию

Страница: 295 / 430

Host Machine Enablement (DocuSP)
GBC FusionPunch II Service Manual
12/2003
6-23
The New Queue Setup Window will display, as shown in Figure 6-26.
Figure 6-26 The New Queue Setup Window
3. Go to the Queue Name field and enter the name of the queue to be
set up, as follows:
• GBC Punch
• For any other finishing device, enter the name as it appears in its
Finisher Profile sheet.
4. Go to the Extended Options field and select Output, as shown in
Figure 6-26.
The Output Window will display, as shown in the information that follows.
This information consists of Print Queue Setup procedures for the
following finishing devices:
• GBC Punch Queue Output (for the FusionPunch II)
• GBC Punch Short Edge Queue Output (for the FusionPunch II)
• SBM1/SBM2 Queue Output (for the Signature Booklet Maker)
GBC Punch Queue Output
Figure 6-27 The Print Queue Output Window
5. Refer to Figure 6 - 27 above and fill in or choose the fields, as
specified in the table below, for a GBC Punch Queue output.
Item Entry
a 2-Sided (Do not check the override option)
b System Specified
c Check the Override option
d System Specified
e Check the Override option
f GBC
g Check the Override option
h Click OK, then OK again in new Queue Setup window
a
d
e
f
g
b
c
h
Queue
Name
Output
Extended
Options
Fields