GBC FusionPunch II, Руководство по обслуживанию

Страница: 113 / 430

REP 5.1 Stacker Drive O-ring
GBC FusionPunch II Service Manual
12/2003
4-17
REP 5.1 Stacker Drive O-ring
Parts List: 5.1 C
WARNING
Switch off the Main Power.
Disconnect the power cord.
Removal
1. If the Stacker has a Bypass Assy installed,
perform REP 5.2 Bypass Assy removal.
2. Make a mark on the O-ring Drive Shaft
(Figure 2).
3. Remove the Stacker Drive O-ring from the
V-pulleys (Figure 2).
4. Loosen:
4.1 the 2 setscrews in the 2 V-pulleys
(Figure 2).
4.2 the 2 setscrews in the 2 Clamp Collars
(Figure 2).
4.3 the setscrew in the Clamp Collar holding
the O-ring Drive Belt Pulley (Figure 1).
5. Remove the e-clip (Figure 2).
6. Slide the Transfer Shaft towards the back of
the machine and remove the Stacker Drive
O-ring from that Shaft (Figure 2).
7. Slide the Drive Shaft towards the front of
the machine until you can remove the O-
ring from the Drive Shaft.
Replacement
1. Replace the Stacker Drive O-ring.
2. Reinstall the parts in reverse order.
MARK
THE
SHAFT
E-CLIP
SETSCREWS
(4)
STACKER
DRIVE O-RING
O-RING
DRIVE BELT
PULLEY
TRANSFER SHAFT
Figure 1.
Figure 2.