GBC Falcon 60+ (-1), Руководство по эксплуатации и обслуживанию

Страница: 30 / 64

30
I
OPERATING INSTRUCTIONS
FILM LOADING & THREADING
The top and bottom rolls of
laminating film must be of the same
width and be present
simultaneously. A small amount of
adhesive will “squeeze out” during
lamination. Hardened adhesive
deposits can damage the heat
rollers. To avoid any damage,
select “Low-Prs LAMI.” for job
mode ( ), rotate the rollers at
slowest speed with heat on. Refer
to the section entitled
CARING
FOR THE FALCON 60+ (-1)
LAMINATOR for instructions
regarding removal of the
accumulated adhesive.
Adhesive will deposit on the rollers
if:
- Only one roll is used.
- Different widths of rolls are
loaded together.
- Either roll is loaded adhesive
side against a heat roller.
- One or both rolls of film are
allowed to run completely off its
core.
The adhesive side of the film is on
the inner side of the web (Figure
20). The shiny side of clear film
must contact the heat rollers. The
dull side of the film contains the
adhesive. Use extreme caution
when loading delustered (matte)
film as both sides appear dull.
Always change the top and bottom
supply rolls at the same time. Near
the end of each roll of GBC
laminating film is a label stating
“Warning-End of Roll”. The
appearance of this label on either
the top or bottom roll requires that
new rolls of film be installed as
soon as the item presently being
laminated completely exits the rear
of the laminator. Do not introduce
any additional items into the
laminator when the warning label is
visible.
To load a roll of film; (Figure 21)
1. Pull the clevis pin up.
2. Swing shaft outward.
3. Slide the roll of film onto the film
shaft ensuring adhesive side is
out.
4. Push the film shaft back into the
film shaft support saddle.
5. Push the clevis pin down.
6. Center the roll of film.
Fig. 20
Fig. 21
Po
ly-i
n
Adhes
ive
sur
fac
e
Polyester surface
Po
ly-out
Adhes
ive
sur
fac
e
Polyester surface
1
5
2
3
4
6
=
Preliminary
Copy