GBC Falcon 60+ (-1), Руководство по эксплуатации и обслуживанию

Страница: 28 / 64

28
I
V. REAR TABLE LATCHES: (Figure
17) Located under the left and right
sides of the rear table.
W. REAR TABLE: (Figure 17)
Provides a working surface when
operating the machine from the
rear. This table may also be
lowered when webbing for roll to
roll aplications.
To lower, pull the left and right side
rear table latches in and lower the
the rear table.
X. REAR RUN/ STOP SWITCH:
(Figure 18) Located on the right
side of the laminator from the rear
operating position. This switch
permits run (1) / stop (2) control of
the motor from the rear operating
position.
Y. FILM WEB: Laminating film
loaded into the machine.
Z. NIP POINT: The point at which
the top and bottom rollers come into
contact. The Nip Point of the heat
rollers is the place at which the
items for lamination are introduced
into the laminator.
a. REAR SLITTER: (Figure 19)
Used to cut off the laminated web.
To use, push down on the blade
engage lever (1) and slide across
the rear slitter rail (2) to the
opposite side.
b. SEPARATOR BAR: (Option)
(Figure 19) Required if running
Accushield™ material. To install,
remove the rear slitter and position
the separator bar in it’s place.
(Falcon 60+ (-1) Part # 2020577)
Fig. 17
Fig. 18
Fig. 19
(V)
(W)
(1)
(2)
(X)
(1)
(2)
(a)
(b) - Option
Preliminary
Copy