Parts changing
Titan 165/ 110 Technical Service Manual
Page 3 - 5
© GBC Films Group October 2000
3.2.2 Replacing the heater(s)
a) If installing new heaters, remove the two nuts and
two flat washers from both ends proir to installing
the new heaters
b) Carefully slide one end of the heater into the
machine from the control side.
c) Once the heater has reached the end of the drive
side, guide the threaded shaft of the heater through
the hole of the heater support plate.
d) Replace the heater bracket to the heater support
arm and secure in place with the two phillips head
screws.
C A U T IO N
E nsu re the nut is secure on the heater!
L oose connection m ay cause
therm al build up
e) Replace one nut and one flat washer on the heater.
This should be positioned about 1/4 inch in from
the end of the threaded stud. Do this for both sides.
f) Replace the heater wire, slide the second flat
washer then the remaining nut and secure all in
place with an 8 mm wrench. Do this for both sides.
g) Replace the cabinets as described in Section
3.1.2.
H e a te r
H e a te r s u p p o rt a rm
H e a te r s u p p o rt p la te
H e a te r w ire
D riv e
s id e
