Servicing
Titan 165/ 110 Technical Service Manual
Page 1 - 3
© GBC Films Group October 2000
a) Turn the MAIN POWER to the “ I ” position.
C aution sh ould alw ays b e exercised
w h en u sin g th e lam in ator w ith
th e safety sh ield s rem oved .
Y ou can be seriously H U R T or IN JU R E D !
W A R N IN G
b) Remove the main roller safety shield, pressure
plate and feed table.
c) For pressure sensitive adhesives: put on the
rubber gloves and use isopropyl alcohol and a
terry cloth towel.
d) For thermal adhesives: while the laminator is at
normal operating temperature, put on the rubber
gloves and use the rubber cement eraser. This
allows the eraser to bead up the adhesive.
CAUTION
Excessive pressure can destroy the silicone
layer by pressing to hard or scrubbing
too long in one spot.
CAUTION
Do NOT pick or pull heat activated adhesive
off the rolls when they are cold. You can
cause irreparable damage to the
laminating rolls.
IN F O R M A T IO N
W h en clean in g th e low er m ain roller,
rep lace th e feed tab le an d p ress R E V E R S E .
W h en clean in g th e low er p u ll roller,
p ress R U N to rotate th e roller th en p ress
S T O P . T h is w ill p reven t an yth in g from
b ein g p u lled in to th e n ip .
W A R N IN G
W h en op eratin g th e lam in ator u sin g th e
foo tsw itch , keep h and s and fin gers aw ay
from th e n ip of th e rollers.
Y ou m ay b e C R U S H E D or B U R N E D !
e) Since the safety shield has been removed, you
must replace the feed table and use the footswitch
to rotate the bottom rollers after cleaning a section.
