GBC AdvancedPunch Pro, Руководство по обслуживанию

Страница: 69 / 400

GBC AdvancedPunch Pro
11/07/2018 RAPS
2-43
4 SOLENOID CHECKS
RAP 4.1 Check Solenoid SOL 1
Solenoid SOL1 is the diverter solenoid- mechanical adjustment is covered
in detail in ADJ 1.2 Diverter Solenoid Adjustment.
1. Open the front the door and insert an Interlock Cheater into the
Punch Door interlock Switch SW4 (PL 2.2).
WARNING
Moving Parts, keep hands clear of nips and the belts when
the Interlock Cheater is inserted. See Section 0, page vii
for other languages.
2. Do GP 6.2.10 SOLENOIDS Procedure to activate and deactivate
Solenoid SOL1.
The diverter gate should rise and fall when SOL1 is cycled.
Diverter gate rises and falls when SOL1 is cycled
Yes - Return to the RAP that directed you here
No - Go to Step 3 and choose the appropriate condition
3. If SOL1 does not function, do the below steps:
• Do REP 1.6 to remove the Rear Cover.
•
Check the cable from the solenoid to the in-line header. This
cable is part of the solenoid body.
• Check the cable 023N01351 (see Section 7 Wiring) that connects
the in-line header to the Main Control Board.
• Replace the SOL1 (REP 2.28.1) or 023N01351 (PL 7.3), as
needed.
If SOL1 functions, do the below steps:
• Go to ADJ 1.2 and perform adjustment if necessary.
This clears the fault
Yes - Return to normal operation No - Go to Step 4
4. Do GP 6.2.16 FIRMWARE UPGRADE Procedure to Re-flash the
firmware for the AdvancedPunch Pro.
This clears the fault
Yes
- Return to normal operation;
No
- Go to Step 5
5. Do REP 2.28.1 Diverter Solenoid Replacement .
This clears the fault
Yes - Return to normal operation; No - Go to Step 6
6. Do REP 7.1 Main Control Board Replacement .
This clears the fault
Yes - Return to normal operation; No - Escalate to second level
RAP 4.2 Check Solenoid SOL 2
Solenoid SOL 2 is the Punch Clutch, see:
• RAP 2.4 Jam Type D.
• RAP 2.7 Multiple Sheets Jammed - Die Pins Partially Through the
Sheets.