GBC 620os
Operation Manual
© 2007 General Binding Corporation
Page 10
FEATURES/ACCESORIES GUIDE
Figure 5
Figure 6
Figure 7
Figure 8
IN-LINE SLITTERS
(
Fig. 5– Item L
)
The
In-Line Slitters
allows the operator to slit film before
it passes through the
Main Rollers
. The trimmed waste can
then be attached to the
Rewinder Tube
and disposed of
later.
COOLIN TUBE
(
Fig. 5– Item M
)
The
Cooling Tube
gives the operator the option of cooling
the media after it passes through the
Main Rolls
. This can
be activated on the
Main Display Panel
.
GUIDE RULER
(
Fig. 5– Item N
)
The
Guide Ruler
helps the operator align the
Slitter
Blades
accurately and helps align images to the film.
IDLER BAR
(
Fig. 5– Item O
)
The
Idler Bar
is used to give the film more dwell time over
the
Heat Roller
. It also assists in smoothing out the film
before it enters the Nip.
NIP ROLLER
(
Fig. 6– Item P
)
The
Nip Roller
is a silicone roll and does not heat up. The
Main Heat Roller
is lowered onto the
Nip Roller
to create
pressure needed for laminating.
MAIN HEAT ROLLER
(
Fig. 6– Item Q
)
The
Main Heat Roller
is Teflon coated & heats up to the
desired set temperature activating the film for lamination.
BURST ROLLER PRESSURE GAUGE
(
Fig. 7– Item R
)
The
Burst Pressure Gauge
indicates how much PSI is
being supplied to the Burst Rollers. Different gages of
paper may require changes to the pressure of the
Burst
Roller.
BURST ROLLER PRESSURE GAUGE KNOB
(
Fig. 7– Item S
)
The
Burst Roller Pressure Knob
allows the operator to
increase or decrease the amount of PSI supplied to the
Burst Roller
.
NIP ROLLER PRESSURE GAUGE
(
Fig. 8– Item T
)
The
Nip Roller Pressure Gauge
indicates how much PSI
is being supplied to the
Main Heat Roller
and
Pull
Rollers
. Different gages of paper may require changes to
the pressure of the
Main Heat Roller
.
NIP ROLLER PRESSURE GAUGE KNOB
(
Fig. 8– Item U)
The
Nip Roller Pressure Knob
allows the operator to
increase or decrease the amount of PSI supplied to the
Nip
Rollers
, and the
Pull Rollers
.
