Gazer PA 40F, Руководство пользователя

Страница: 14 / 48

14
EN
• The installation of the unit at the place, not protected against the ingress of water, should not be allowed because the device
is untight and vulnerable to the influence of water.
• Secure the central unit reliably with double-sided adhesive tape or plastic ties.
• During the installation of the unit, avoid the places close to pulse or high-voltage cables and units of the automobile.
Laying of the wiring:
• Lay the connection wiring from the central unit to the bumper with the installed sensors.
• Connect the wiring to the sensors. The sensors should be connected from left to right according to the pattern as follows:
Note: The sequence of the connection of sensors can be changed by transposing the connectors on the central unit.
•
Fasten the wiring by plastic ties.
• Avoid a strong tension of wires.
• While laying the wiring, avoid pulse and high-voltage cables. In order to ensure the integrity of the wiring, it is expedient to
avoid heating and moving parts of the automobile.
• Make sure that the place, where the cable runs from the cabin, is tight. To make the output more convenient, a rubber gasket is
provided for on the protective corrugation of the cable.
Guidance on installation