Gazer PA 40F, Руководство пользователя

Страница: 13 / 48

13
EN
Guidance on installation
Installation of sensors:
Important: Do not install the sensors into the metal bumper because it will lead to the inoperability of the system.
• It is recommended that the sensors be installed at proper places. The majority of automobile makers apply the marking for drilling
holes on the rear side of the bumper.
• In the event that the marking is absent or the installation is impossible at proper places for any reason, in order to mark the holes,
use a marking ruler included into the set of the system.
•
It is recommended that the height of the installation of the sensors be not lower than 40 cm.
• Install the sensors not lower than the height recommended (take into account the possibility of loading the automobile).
• The sensors should not abut upon the elements of the body by their rear portion of the housing.
• It is recommended that the drilling of holes be made with a supplied milling cutter.
• Take into consideration that the working surface of the sensor should be at an angle of 90° relative to the ground surface.
• Use spacing bushes to compensate the bumper inclination angle for the PA40F systems.
• In order to install the sensors correctly relative to the horizon, orient by the marks on the sensor housing. On the spacing bush
there is a point that indicates the top of the sensor. On the rear portion of the housing there is a mark in the form an arrow,
pointing at the top during the installation.
•
The sensors should abut tightly upon the external surface of the bumper.
Installation of the central unit:
•
It is recommended that the central unit be installed at the water-protected place of the cabin or in the underhood space of the
automobile.
• Choose the installation place so that a normal laying of the connecting cables can be done, and the length of cables will be
sufficient to connect sensors, the power supply and a loudspeaker.