Gateway Solo 2200, Руководство пользователя

Страница: 75 / 82

User’s Guide 75
Something is wrong with the display:
u Make sure an image appears on the screen (Windows 95 desktop).
u Make sure that the brightness is turned up. The screen may be simply too
dark to see.
u Make sure the
Auto dim with battery only
option in the
Power
menu is set
to
OFF
.
u Press FN+F3 to cycle the system back to LCD panel mode. It is possible it
is in CRT mode.
General
Even after the system is on and running, you may encounter one or more of
the following problems. If any of these happen, check the appropriate parts
and their connectors, then try the solutions suggested:
The system date says January 1, 1980
The internal battery that keeps the clock/calendar going ran completely
down. This can happen if you leave the battery pack out of the system or
fully discharged for a day or more. To correct the problem, reset the date in
the
Main menu
. Then plug the AC adapter into the notebook and leave it
attached for an hour or so.
The screen says, ”General Failure reading drive C:“
Try rebooting a couple of times by pressing Ctrl+Alt+Del. Make sure the
system isn’t too cold. If nothing works, call Gateway 2000 Customer
Support.
The screen says, ”Non-system disk or disk error reading drive A:“
You have a non-bootable disk in drive A: (the floppy disk drive). Remove it
and press any key.
The screen says, ”Bad command or file name“
You may have mistyped a command. Retype the command or check your
operating systems manual. A bad command or file name may be in the
AUTOEXEC.BAT or the CONFIG.SYS file. The boot sector may have been
altered by a virus.
For information on other error messages, refer to the manuals that document
your operating system.