50
Gateway Solo™ 2200 Multimedia Notebook
Using a Modem
Installing and using a modem with the Gateway Solo™ 2200 Multimedia
Notebook is an easy process. If you have ordered TelePath
®
data/fax modem
with your notebook, the drivers for the modem have already been
preloaded onto the system.
Caution: Do not use your TelePath modem on a digital phone line. Modems
convert digital signals into analog signals that can be sent on normal, ana-
log telephone lines. If you attempt to use the modem on a digital line, the
TelePath data/fax modem has built-in protection, and will not work. Some
modems could become permanently unusable. Most digital lines are in-
house PBX systems. If you have any doubts about the type of line you have,
ask your telephone service supplier.
To install the TelePath data/fax modem:
1.
Using the 15-pin connector: Plug the 15-pin connector end of the
modem cable into the end of the modem (see Figure 45). If you have
trouble plugging it in, turn the connector over.
Using the XJACK: Gently push on the end of the jack and release. The
jack will pop out. Plug an RJ-11 connector from above into the XJACK
(see Figure 46).
2. Insert the modem face up, 68-pin connector first, into the PC Card slot in
the left rear side of the notebook. Press the modem gently, but firmly into
the PC Card slot until it will go no farther. Do not force the modem.
3. Plug the jack end of the modem cable into the RJ-11 wall jack. Use an RJ-
11 connector and extension telephone cable if you need a longer cord
for your modem.
4. The modem is now enabled and ready to use.
RJ-11 connector
XJACK
Figure 45. Making a 15-pin Connection
Figure 46. Making an XJACK Connection
15-pin connector
Содержание Solo 2200
