Gateway GT5042j, Справочник по аппаратуре

Страница: 35 / 48

CHAPTER 3: Maintenance Basics www.gateway.com
32
Caution
Do not touch the contacts on the bottom
part of the expansion card. Touching the
contacts can cause electrostatic damage
to the card.
6
Install the new card into the expansion slot. You can slightly seesaw the
card end-to-end to help insert the card, but do not bend the card
sideways.
7
Replace the thumbscrew in the expansion card cover.
8
Reconnect the expansion card cables (if any) using your notes from Step 4 ,
or, if adding a new card, follow the manufacturers instructions.
9
Return your computer to its upright position.
10
Replace the side panel by following the instructions in “Replacing the side
panel” on page 15 .
Replacing the system board
To replace the system board:
Tips & Tricks
You need a Phillips screwdriver to replace
the system board.
1
Remove the side panel by following the instructions in “Removing the side
panel” on page 12 .
2
For more stability, place your computer on its side. To avoid scratching the
case, place it on a towel or other non-abrasive surface.
3
Disconnect any cables that are attached to any expansion cards, noting
their locations and orientation. (You will reconnect the cables after you
install the cards on the new board.)
4
Remove the expansion cards by following the instructions in “Adding or
replacing an expansion card” on page 31 . You can slightly seesaw a card
end-to-end to loosen it, but do not bend a card sideways.