Gateway E-9425R, Руководство пользователя

Страница: 64 / 128

CHAPTER 4: Installing Components www.gateway.com
58
6
Locate the old battery on the system board and note its orientation. You
will need to install the new battery the same way.
7
Push the battery retention clip away from the battery until the battery lifts
up, then remove the old battery. You can use a screwdriver to help lift the
battery.
8
Make sure that the positive (+) side of the new battery is facing the correct
direction, then press the new battery into the socket until it snaps into
place.
9
Follow the instructions in “Closing the server case” on page 32 .
10
Turn on your server, then press F2 when the Gateway logo screen appears
during startup. The BIOS Setup utility opens.
11
Restore any BIOS settings that you wrote down in Step 3 .
12
Save all your settings and close the BIOS Setup utility.
Replacing the control panel
Caution
Your server must be operated with a
control panel module in place.
To replace the control panel:
1
Follow the instructions in “Preventing static electricity discharge” on
page 30 . Make sure that you turn off the server, then unplug the power
cord(s) and all other cables connected to the server.
2
Follow the instructions in “Opening the server case” on page 31 .
3
Unlock the bezel (if necessary) and remove it by pulling it straight out from
the front of the chassis.
4
Disconnect the cables from the control panel.