Gateway E-9425R, Руководство пользователя

Страница: 43 / 128

Installing and removing drives www.gateway.com
37
7
Push the lever back into place until it latches.
8
Reinstall the bezel, if required, by snapping it into place on the front of
the chassis.
Installing an optional diskette drive
The optional diskette drive kit includes a slimline diskette drive, a 3.5" mounting
adapter bracket, 4 screws, and a thumbscrew. The 3.5" adapter bracket fits in
the left most 3.5" hard drive bay. There is a thumbscrew to secure the bracket
to the chassis. Installation of the optional diskette drive uses one of the hard
drive bays, so your server can only hold as many as three hard drives after the
installation.
To install an optional diskette drive:
Caution
The diskette drive is not hot-swappable.
Before installing or removing the drive,
make sure that power is turned off and
the power cord is unplugged.
1
Follow the instructions in “Preventing static electricity discharge” on
page 30 . Make sure that you turn off the server, then unplug the power
cord(s) and all other cables connected to the server.
2
Unlock the bezel (if necessary) and remove it by pulling it from the chassis.
3
Follow the instructions in “Opening the server case” on page 31 .
4
Remove the hard drive from the left-hand hard drive bay by following the
instructions in
“Removing and installing a hard drive” on page 36 .
5
Insert the diskette drive into the mounting adapter and secure it with the
four screws provided in the kit.
6
Insert the diskette drive/adapter assembly into the left-hand hard drive
bay, then secure it with the thumbscrew that came with the kit.
7
Connect a USB cable from the USB floppy drive connector (J27) on the
system board to the back of the diskette drive.
8
Follow the instructions in “Closing the server case” on page 32 .
9
Reinstall the bezel, if required, by snapping it into place on the front of
the chassis.