Gates Underwater Products, Inc
13685 Stowe Drive • Poway, CA • 92064 • 858.391.0052 • 800.875.1052 • Fax 858.391.0053
[email protected] • www.GatesHousings.com
03/09/13
7
Preparing the Housing
Release the latches.
Release the three stainless steel safety latches that secure
the housing halves. They have a
positive locking
feature, so to open them you must
first depress the center bar release while lifting the rear lever.
Open the housing.
Separate the rear half of housing from the front.
Remove the camera tray from the housing.
The tray is released by rotating the
locking latches 90 degrees in opposite directions. Refer to the drawing below. Once
released, the tray will easily slide out of the housing.
Pull out controls
on the left side of the front shell as far as they will go. Note that
controls will be addressed in greater detail in a subsequent section.
Pull out video and audio connectors
(if applicable) and wrap to the side or top of
the housing out of the way for camera insertion.
To remove the camera
tray rotate the latches
90 degrees.
