Gates Underwater Products, Inc
13685 Stowe Drive • Poway, CA • 92064 • 858.391.0052 • 800.875.1052 • 858.391.0053
[email protected] • www.GatesHousings.com
10
03/09/13
Secure the camera
in the housing by locking the latches. They will have a positive
‘snap’ into position when rotated to the rear of the tray.
Check controls
. With the camera turned on and installed into the housing front,
press in each control and confirm proper operation (refer to the next section for more
detail on controls).
Tip
:
With the camera installed you can now get a good view inside the front
half of the housing and most controls. Use a flashlight if necessary to become
familiar with the operation and ‘feel’ of each control in their proper position prior to
closing the housing.
Plug in the video connector
if you are using an external monitor.
Tilt the camera viewfinder
for proper alignment with the viewfinder on the housing.
Tilt approximately 10 degrees, as shown in the photo.
Connect the optional HD-SDI Surface Feed
BNC connector to the HD-SDI video
out connector.
Secure the camera tray by rotating the
locking latches 90 degrees to the rear.
Push in all controls and verify
operation.
Slide the camera into the housing.
It should do so without obstruction
and mate with the alignment collar
behind the port opening.
