Gates Underwater Products PMW-200, Руководство по установке, использованию и уходу

Страница: 25 / 26

Gates Underwater Products, Inc
13685 Stowe Drive • Poway, CA • 92064 • 858.391.0052 • 800.875.1052 • Fax 858.391.0053
Customer.srvc@GatesHousings.com • www.GatesHousings.com
03/09/13 25
Loosen the thumbscrews,
slide the monitor onto the
top rail, then tighten
gently to secure.
Optional External Monitor
This section covers mounting of the optional monitor to the PMW-200 housing and
connection to the camera. Refer to the Setup, Use and Care guide for the monitor to be
used with the PMW-200 housing for other details. The Gates EM43 monitor is shown
here for reference.
Camera connection and setup

Connect to the camera by plugging in the video cable located inside the housing.
The video cable will plug into the composite connector on the right side of the
camera.

Verify operation. You can check proper operation at this time by plugging in the
monitor (see below) and turning on the camera. The camera must be setup to
display recording data and other information on the monitor by setting the following
menu selection:
MENU

VIDEO SET

SDI/HDMI/Video Out Super

ON
Monitor mount and connection

Slide the dovetail and monitor into the grooves on top of the housing and tighten in
place with the thumbscrews.

Plug in the monitor cable to the housing bulkhead connector, which is found on the
right side of the housing.

Caution : If you are not using the monitor for any reason, do not plug the RCA
connector into the camera.

Verify operation once again to ensure all is working properly prior to use in water.