17
DISASSEMBLING THE BLENDER JUG AND REMOVING STUBBORN
RESIDUE
WARNING:
The blades of the knife are very sharp. Treat the blades careful-
ly and without violence, be careful not to cut on the sharp blades and not to dama-
ge the blades.
8. Keep the blender jug over a sufficiently large bowl, turn the mount to the left and
remove knifes and the sealing ring downwards.
9. Rinse all parts of the mixing jar in warm detergent solution. Soak the stubborn
food residues on the parts for a few minutes and then remove these with a small
plastic brush or sponge. While doing so be careful not to cut on the sharp
blades.
10. Rinse the parts of the blender jug with clear water and dry the parts afterwards
with a clean cloth gently. Let the parts (especially blades and bottom of the jug)
dry in a protected and inaccessible to small children area at the air. Place the
parts back together after drying (see ›Assembling the Blender Jug‹).
CLEANING THE MOTOR BLOCK
WARNING:
Always unplug the power cord before cleaning the motor base.
Never pour water or other liquids on the motor base pour, run into the motor base
or under the motor base. Never immerse the motor base in liquids or place on wet
or damp surfaces. Wipe away spilled liquids immediately. At the bottom of the motor
base are vents. Please ensure that no water can run or drip into these openings.
1. Unplug the power plug from the outlet.
2. Then wipe the motor base with a damp, not dripping cloth. Make sure to avoid
damaging the drive wheel and bearing of the drive wheel in the centre of the
socket. Never poke with fixed or hard objects in the mount of the motor base.
Use a soft brush if necessary to clean the mount. If moisture gets into the mount
of the motor base, clean and dry the mount very carefully and thoroughly.
3. Dry the appliance thoroughly. The entire motor base must be completely dry
before you reassemble the appliance and use.
