CARE AND CLEANING
WARNING:
To avoid injury to persons and damage, always turn the appliance OFF ›O‹, wait
for the motor to stop completely and unplug the appliance, immediately after operation and
before assembling/disassembling or cleaning the appliance.
ATTENTION:
Do not use abrasive cleaners, cleaning pads, corrosive chemicals (disinfect-
ants, bleach) or any sharp or hard objects (i.e. metal scouring pads) for cleaning, for this could
damage the surfaces. Always handle the entire appliance with care and without violence.
1. Unplug the appliance from the power outlet before cleaning.
2. Remove Bean Container by turning counterclockwise to ›OFF‹, then lift straight up.
3. Remove the Ground Coffee Container by pulling out from the left-hand side of the Coffee
Grinder.
4. The Removable Ground Coffee Container, Bean Container and Lid should be washed in
warm soapy water, rinsed and dried thoroughly.
5. Polish with a soft, dry cloth. Do not use abrasives. When the units are dry assemble the appli-
ance for storage or usage.
Cleaning the motor housing
WARNING: Do not
place the appliance or any parts of it in an automatic dishwasher or pour
boiling water over it. Do not immerse the motor or power cord in any liquids or spill any liquids on
it or place the motor on wet surfaces. Always wipe off spilled liquids immediately. When liquids are
spilled on the motor housing, immediately unplug the appliance and dry the motor housing to
avoid risk of electric shock or fire.
Do not
attempt to operate the appliance, when liquids are
on or in the motor housing.
1. Always turn the appliance OFF ›O‹, wait for the motor to stop completely, and unplug
the appliance from the power outlet before you start cleaning the motor housing.
2. Wipe the motor housing and power cord with a damp soft cloth. Take care not to spill or
drip water or any other liquids on the motor housing.
ATTENTION:
Ensure not to damage the Grinding Gear. Never poke with anything into the
motor housing. If necessary use a soft brush for cleaning. If any liquids run into the motor
housing clean and dry the motor housing very carefully.
3. Thoroughly dry the motor housing after each cleaning or leave it dry naturally where it is
out of reach of young children. Polish with a soft, dry cloth. Afterwards assemble the appli-
ance.
4. You can take out the outer ring of the Grinding Gear for cleaning.
Use a small soft brush for cleaning it. Do not use water for cleaning.
Water can damage the Grinding Gear or the units might rust. Watch the
cannelure when assembling the Grinding Gear. Ensure the outer ring
of the Grinding Gear is lockered into position and properly assembled
(you might have to turn the unti a little bit to place it in the cavity).
Picture A
22
A
