30
31
oPerAting
BeFore First Use
Rinse all the parts of the appliance with water that come into contact with food and
clean them with dishwashing detergent. Operate according to the instructions ›Care
and cleaning‹.
AssemBling the APPliAnce
wArning:
The work space has to be easily accessible, solid, even, dry and of
sufficient size. The mincer should only be set up on a firm level work surface. Never
place the appliance close to the edge of the working area. Ensure that the power
supply cable does not hang down from the work surface as it could be easily pulled,
particularly by small children, thereby causing serious accidents. DO NOT put any
cloth or napkins underneath the appliance to avoid endangering by fire and electric
shocks. NEVER place the appliance on paper towels or uneven working areas. The
air has to able to circulate.
imPortAnt:
Always ensure that the plug is not con-
nected to the power outlet before assembling or disas-
sembling the appliance. Place the mincer on a flat, dry
surface such as a bench top.
AssemBling For mincing
1. Loosen the screw plug on the right side of the mincer
by turning it counterclockwise until you can fit the
slim end of the worm housing all the way into the
opening for the drive shaft. The opening of the worm
housing should be upright (picture A). The worm hou-
sing is correctly mounted when the worm housing is
flush with the motor housing. You should not be able
to see the slim end of the worm housing anymore.
Turn the screw clockwise for tightening. Do not use
force and be careful to not overwind the screw thread.
2. Insert the worm with the longer, narrower end into
the worm housing and turn slightly until it is securely
seated in the worm housing (picture B). Make sure
that the worm is placed completely in the inside of
the worm housing.
If necessary turn the worm a little bit to make it fit. If
mounted correctly only round about 9 mm of the axis
of the worm are visible outside of the worm housing.
A
B
C