Gaspardo SD Series, Использование и обслуживание

Страница: 32 / 48

USE AND MAINTENANCE
30
ENGLISH
cod. 19501980
g
3.0. INSTRUCTIONS FOR USE
To obtain the best performance from the equipment, carefully
follow what is set up below.
ATTENTION
All maintenance work, adjustments and preparation for
operation, must be carried out with the power take-off
of the tractor disconnected, the seeder on the ground
on its supporting feet, the tractor not running, the
wheels blocked and the key turned off.
3.0.1. ATTACHMENT THE TRACTOR
The seeder may be attached to any tractor fitted out with a
three-point universal joint.
DANGER
The attachment to the tractor is a very dangerous phase.
Be sure to follow the instructions carefully throughout
the operation.
The correct tractor/seeder position, is determined by placing
the equipment at a distance from the tractor so that the Cardan
joint remains extended by 5-10 cm from its maximum closing
position. At this point, proceed as follows:
1) Hook the lifter bars onto the pins provided (1 Fig. 8) Block
with the snap split pins.
2) Hook the chains to the lifting bars of the tractor. Using the
tierods block the bars parallel to the tractor. This expedient
must be used to avoid any kind of horizontal movement of
the seeder.
3) Connect the third upper point (2 Fig. 8-9); the pin will be
blocked with the appropriate split pin; use the adjusting tierod
(1 Fig. 9) to keep the seeder perpendicular to the ground
(Fig. 10)
4) Connect the Cardan shaft and make sure that it is perfectly
blocked on the power take-off. Check that the guard turns
freely and fix it with the chain provided.
3.0.2. ADAPTING THE CARDAN SHAFT
The Cardan shaft, supplied with the machine, is of standard
length. It might, therefore, be necessary to adapt the cardan
shaft. Should this be the case, before proceeding, consult the
Manufacturer.
CAUTION
- When the Cardan shaft is with drawn to the end of
its stroke, the two pipes should ovelap by at least 15
cm (A Fig. 11). When it is inserted all the way, the
minimum admissible play is 4 cm (B Fig. 11).
- When using the equipment on another tractor, check
that conditions are as stated above and check that
the guards complete ly cover the rotating parts of
the Cardan shaft.
ATTENTION
For transportation of the seeder, always follow the
Manufacturer's instructions.
2
1
fig. 9
fig. 11
fig. 8
2
1
1
90
90
fig. 10