Garudan GOV-1004-24, Руководство пользователя

Страница: 16 / 79

© ANITA
MP04000EN_190301 16
4. Changing and adjusting presser foot set
Turning adjusting screw (1) counterclockwise in order to
loose pressure spring. Loosen screw (2) can take-off presser
foot set.
Adjusting:
Presser foot must be installed correctly in order to obtain best sewing effects.
1. Turning hand wheel in order to lower the needle bar to
its lowest set position and needle can by moved into needle
hole.
2. Make sure the needle hole of presser foot in line with the
needle hole of needle plane and sewing needle is in the
center of needle hole. In the meantime, the bottom of
presser foot should lay flat on the top of needle plate (Left
diagram)
3. Tighten screw (2)
4. The bottom of presser bar should hold presser arm
properly. So, presser arm can be held and release easily
whole adjusting, loosen screw (4) move shaft (3) to right or
left in order to set up correct position.
www.garudan.cz