Garudan GOV-1004-24, Руководство пользователя

Страница: 21 / 79

© ANITA
MP04000EN_190301
Setting up chain stitch looper:
When chain stitch looper moves to its utmost left
position, the distance between tip of chain stitch
looper and the center of chain stitch needle should
be 1,5 mm. Adjustment can be made by loosen
screw (1).
When changing the size of needle or when
looper. Please refer to Diagram 1.
1. Please open up back cover (1) of sewing machine.
2. Loosen screw (3) a little bit (Please do not loosen screw (3) completely).
3. Turning adjusting screw (2).
4. Turning toward (+) direction in order to obtain bigger movement. Turning toward (
order to obtain smaller movement.
5. After adjustment, please make sure tighten screw (3) and back cover (1).
When chain stitch looper moves to its utmost left
distance between tip of chain stitch
looper and the center of chain stitch needle should
be 1,5 mm. Adjustment can be made by loosen
When tip of looper moves to the center of
chain stitch needle, the tolerance between
looper tip and needle grove should be
0 – 0,05 mm. Adjustment can be made by
loosen screw (1).
When changing the size of needle or when adjusting the front and rear movement amount of tip of
looper. Please refer to Diagram 1.
lease open up back cover (1) of sewing machine.
Loosen screw (3) a little bit (Please do not loosen screw (3) completely).
4. Turning toward (+) direction in order to obtain bigger movement. Turning toward (
order to obtain smaller movement.
5. After adjustment, please make sure tighten screw (3) and back cover (1).
21
When tip of looper moves to the center of
chain stitch needle, the tolerance between
tip and needle grove should be
0,05 mm. Adjustment can be made by
adjusting the front and rear movement amount of tip of
4. Turning toward (+) direction in order to obtain bigger movement. Turning toward (-) direction in
www.garudan.cz