2.2.
TOUCHPADS
A total of eight touchpad controls are located in the overhead control panel. All of the touch-
pads, except
ACCESS
, may be used by the operator according to the supervisor’s instruc-
tions.
2.2.1.
OPERATE
The
OPERATE
touchpad is used to turn on the PD 6500, initiate a self test and place the PD
6500 in Operate mode within ten seconds. Activate the self test any time by pressing
OPER-
ATE
. The operator should inform the supervisor about any problems that appear on the LCD.
(see Section 4)
2.2.2.
OFF
The
OFF
touchpad is used to turn off the PD 6500, ensuring that all of the information and
settings are stored in memory until the detector is ready to resume full operation.
2.2.3.
COUNTER
The
COUNTER
touchpad is used to obtain an automatic update on the traffic count that
appears on the LCD. To return the traffic count to zero, press and hold the touchpad for a few
seconds. If information other than the current traffic count appears on the LCD, simply press
COUNTER
and the traffic count (
CT #)
will appear along with the number of changes that
have been made to program/base sensitivity settings (
SEQ #).
2.2.4.
VOLUME
The
VOLUME
touchpad is used to access the volume control of the audio alarm. Use the
plus (+) and minus (–) touchpads to adjust the volume.
2.2.5.
+ AND –
The plus (
+
) and minus (
–
) touchpads are used to change numerical settings, activate certain
on/off functions and adjust the volume of the audio alarm.
MAGNASCANNER PD 6500
OWNER’S MANUAL
©2000 GARRETT METAL DETECTORS, INC.
6/19/00
PN 1531100
4
Figure 2-2
