MAGNASCANNER PD 6500
OWNER’S MANUAL
©2000 GARRETT METAL DETECTORS, INC.
6/19/00
PN 1531100
10
3.2.
ASSEMBLY (CONT’D)
4.
Open the door of the detection unit. Select a panel for power use (keeping in mind
the location of the electrical outlet) and connect the AC jumper cord to said panel and
the power module. Then, connect cables A and B to the corresponding panels. (See
Figure 3–3.)
5.
Remove power cord from the base of the panel to which the AC jumper cord has
been connected.
6.
Use the four remaining screws and washers to attach the crosspiece to the two
panels as shown in Figure 3–4.
7.
Use two or more people to lift PD 6500 to a vertical posi-
tion and move to desired location. (See Figure
3–5.)
8.
Ensure the PD 6500 is physically stable.
9.
Tighten all screws with a slotted screwdriver.
10.
Connect the power cord to the panel chosen
for power in Step 4 and proceed with the
installation adjustments. (See Section 5.)
Figure 3-2
Figure 3-4
Figure 3-5
Figure 3-3
DETECTION UNIT
FLOOR
DETECTION UNIT
FLOOR
CROSSPIECE
PANELS
Styrofoam
Packing Insert
Styrofoam
Packing Insert
PANEL B
PANEL A