Garrett 11674xx, Руководство пользователя

Страница: 31 / 48

10.8.2. OPERATE
When this touchpad is pressed, the Magnascanner CS 5000 activates all circuits, initi-
ates a self-diagnostic program and places the unit in the Operate Mode within 10 sec-
onds. This diagnostic program for instant fault detection can be activated at any time by
touching this
OPERATE pad. If any faults are ever found, they will be immediately
reported on the LCD display. (See Page 10-11.)
10.8.3. COUNTER
Since the current traffic count of the Magnascanner is usually displayed, this touchpad
will be needed only for resetting the counter. Pressing and holding this touchpad for ten
(10) seconds causes the counter to return to zero (0). Whenever the LCD displays
information other than the current traffic count, pressing this touchpad will cause the
count to appear.
10.8.4. VOLUME
When this touchpad is pressed, the volume level of the unit s audible alarm will be dis-
played on the LCD display. By using the
+ and touchpads, operators can raise or
lower the volume.
10.8.5. + A N D
These touchpads will be used to increase or decrease various numerical settings and
for certain On/Off functions.
10.8.6. PROGRAM
When this touchpad is pressed, the settings for Program and Sensitivity will appear on
the LCD display.
All of the preceding touchpad functions will be available to operators of the detector at
all times. The
ACCESS touchpad will be used only by supervisors.
10.9. ACCESS TOUCHPAD
Operators need never touch this control.
This touchpad will be used only by supervisory management personnel. It permits
changing the Program and Sensitivity codes and also is used to control such functions
as synchronization of multiple units, pulse frequency and tone. The unit further protects
security of control settings by maintaining a non-resettable sequence code that indi-
cates any attempt at seeking access to the settings. A
Tamper Alarm sounds within 10
seconds after the ACCESS touchpad is pressed unless a proper access code is
entered. Follow supervisors instructions concerning response to this Tamper Alarm .
28
MAGNASCANNER CS 5000
OWNER S MANUAL
' 2000 GARRETT METAL DETECTORS, INC.
4/30/00 PN 11674XX
Revised