PD-5 Operator Manual
Page 8
SSD destroyer if desired.
Cleaning exterior of unit
When cleaning the unit, make sure that the power is not connected.
Wipe dirt off with a soft and dry cloth.
Do not use chemicals or solvents.
Note:
Use caution when cleaning the unit as some debris is sharp and may contain glass.
Cleaning the Debris Tray
1) Make sure destruction wedge has returned to the top or home position. Wait for motor to stop.
2) Open
Door.
3) Sweep debris from side rails into Debris Tray.
4) Lift and remove Debris Tray.
5) Empty Debris Tray into trash container.
6) Check bottom of crush chamber for additional debris.
If additional debris is found use a small brush to move additional debris to the front
of the destruction chamber. There are two holes that allow debris to be swept out
of the floor of the destruction chamber.
Note:
Placing the Debris Tray under the
front of the PD-5 will catch the debris as it falls from the two holes in the front of the
destruction chamber. (See “Cleaning Tips” below).
7) Replace the Debris Tray and resume the destruction process.
Note:
Make sure that the Debris Tray is inserted all the way to the back of the chamber or the door will not
shut completely.
Cleaning Tip:
You can use the debris tray itself to clear remaining debris from the bottom of the PD-5 as
demonstrated in the images below.
