PD-5 Operator Manual
Page 2
Introduction
The Garner model PD-5 will physically destroy working and non-working hard disk drives (HDD), Network HDD,
Half-Height HDD, Standard HDD and Laptop HDD by bending, breaking and mangling data platters, pc boards
and the frames of the hard drives.
The PD-5 is also designed to destroy solid state memory devises when used with the optional SSD Destroyer
accessory.
Important Instructions
PLEASE READ THIS INFORMATION
BEFORE USING MODEL PD-5 !
This shipment was packaged and delivered to the carrier with utmost care to ensure safe delivery of goods to you,
our valued customer. In the event that you must transport your PD-5 to a different location or to the factory for
repair service, you must package it for safe delivery. Failure to do so may result in freight damage and void
warranty
.
PLEASE RETAIN ALL SHIPPING MATERIALS FOR FUTURE USE.
Please contact Garner
Products, Inc. at (800) 624-1903 for further information if required.
Inspection
1)
Unpack the shipping carton/case and take out the PD-5 Physical Destroyer.
2)
Inspect the PD-5 for shipping damage as soon as it is unpacked. If the PD-5 or any accessories are
damaged or fail to operate correctly, notify carrier and contact your dealer immediately.
3)
Retain all shipping materials for possible future use.
Installation
Voltage
Confirm power requirements as indicated on label located on back of the PD-5. If the identified voltage does not
match your voltage mains, contact Garner Products, Inc. at (800) 624-1903 for further instructions.
Power Plug
Plug the IEC connector attached to the power cord supplied into the receptacle on the back of the unit.
Location
The PD-5 must be place on a flat, hard and secure horizontal surface. Position the PD-5 to allow proper air flow
from the side air inlets and the rear exhaust. A minimum clearance of 6 inches from any obstructing wall or solid
surface is recommended.
Operating Environment
Do not use or keep the PD-5 in environments with excessive heat, cold, humidity, or dust.
