
Dashboard Mounting and External Power
Your StreetPilot is designed with portability in mind--allowing you to easily trans-
port the unit from one vehicle to another or take it with you once you reach your desti-
nation. A dash mount is included in the StreetPilot package, providing a semi-perma-
nent method of installing the unit at the best viewing location for the driver or passen-
ger(s) . The dash mount bracket may either be permanently or temporarily mounted
using included adhesive materials. An installation instruction sheet is included with
the dash mount, which you should refer to for specific instructions. General instruc-
tions are included here for your convenience.
To install the cigarette lighter adapter, locate the connector on the rear of the
StreetPilot unit (behind the rubber weather cap). The connector is “keyed” with a notch
located between two pins. Mate the plug on the cigarette lighter adapter to this connec-
tor by aligning the notches and pushing the plug into the connector until fully seated
(see picture at right). Take care when routing the adapter cable that it does not interfere
with vehicle operation in any way.
Carefully choose the placement
of the base on the dash and
install using either the tempo-
rary or permanent adhesive.
Slide the StreetPilot and mount-
ing bracket into the base until
you hear it snap into place.
Slide the locking lever to the
right to lock the unit and pre-
vent it from sliding off the base.
To remove the unit from the base,
slide the lever to the left, depress
the release tab, slide the unit to the
right, and lift out of the base.
quick-start
D
Daasshh M
Moouunnttiinngg,, E
Exxtteerrnnaall P
Poow
weerr
Ù
5
Содержание StreetPilot GPS
Страница 88: ...78 Notes...
Страница 89: ......