Garmin SOCATA TBM850, Руководство пилота

Страница: 150 / 684

190-00709-04 Rev. A
Garmin G1000 Pilot’s Guide for the Socata TBM 850
136
AUDIO PANEL AND CNS
TRANSPONDER CONTROLS
Transponder function is displayed on three levels of softkeys on the PFD: Top-level, Mode Selection, and
Code Selection. When the top-level XPDR Softkey is pressed, the Mode Selection softkeys appear: XPDR1 ,
XPDR2 , STBY , ON , ALT , VFR , CODE , IDENT , BACK .
When the CODE Softkey is pressed, the number softkeys appear: 0 , 1 , 2 , 3 , 4 , 5 , 6 , 7 , IDENT , BKSP ,
BACK . The digits 8 and 9 are not used for code entry. Pressing the numbered softkeys in sequence enters
the transponder code. If an error is made, pressing the BKSP Softkey moves the code selection cursor to the
previous digit. Pressing the BKSP Softkey again moves the cursor to the next previous digit.
Pressing the
BACK
Softkey during code selection reverts to the Mode Selection Softkeys. Pressing the
BACK
Softkey during mode selection reverts to the top-level softkeys.
The code can also be entered with the FMS Knob on either PFD. Code entry must be completed with either
the softkeys or the FMS Knob, but not a combination of both.
Pressing the IDENT Softkey while in Mode or Code Selection initiates the ident function and reverts to the
top-level softkeys.
After 45 seconds of transponder control inactivity, the system reverts back to the top-level softkeys.
Figure 4-35 Transponder Softkeys (PFD)
Pressing the BACK Softkey
returns to the top-level softkeys.
Pressing the BACK Softkey returns to the mode selection softkeys.
MSG
MSG
BACK BKSP
IDENT
7 6 5 4 3 2 1 0
STBY ON ALT VFR CODE IDENT BACK
XPDR
GND
IDENT
XPDR1 XPDR2
Selecting and activating Transponder 1 or Transponder 2:
1) Press the XPDR Softkey to display the Transponder Mode Selection Softkeys.
2) Press the
XPDR1
or
XPDR2
Softkey to select and activate the other transponder.
When turning on the G1000 for use, the system activates Transponder 1 as the default unit, regardless of
which transponder was active prior to shutdown. When switching between Transponder 1 and Transponder 2,
the code and mode remain the same. If a new code is entered in the active transponder, switching transponders
does not bring back the previous code.