Garmin GPS 400W, Руководство по установке

Страница: 75 / 212

GNS 400W Series Installation Manual Page 4-21
190-00356-08 Rev. G
4.10 DME Tuning (GNS 430W Only)
4.10.1 DME Tuning Function
The GNS 430W can channel a DME based on the tuned VLOC frequency. The GNS 430W outputs 2 of
5, BCD or Slip parallel DME and King Serial DME channeling format. When DME COMMON is held
low, the GNS 430W actively tunes the DME.
4.10.2 DME Tuning Electrical Characteristics
4.10.2.1 Parallel DME Tuning
Pin Name Connector Pin I/O
NAV PAR DME - 8MHZ P4006 14 Out
SER DME
– CHAN REQ/PAR DME – 4 MHz
P4006 20 Out*
SER DME
– RNAV MODE/PAR DME – 2 MHz
P4006 21 Out*
NAV PAR DME
– 1 MHz
P4006 33 Out
NAV PAR DME
– 800 kHz
P4006 37 Out
NAV PAR DME
– 400 kHz
P4006 39 Out
NAV PAR DME
– 200 kHz
P4006 40 Out
NAV PAR DME
– 100 kHz
P4006 42 Out
NAV PAR DME
– 50 kHz
P4006 43 Out
NAV DME COMMON P4006 22 In
* These pins are outputs when the GNS 430W is configured for 2 of 5 parallel DME tuning.
For each of the parallel DME tuning discrete outputs, the driver output voltage is not more than 1.0 V
while sinking 20 mA. The maximum off state leakage current with respect to ground is less than 10 A.
NAV DME COMMON must be pulled low to indicate to the NAV module that it is the device
channeling the DME.
NAV DME COMMON is considered active if either the voltage to ground is < 1.9 V or the resistance to
ground is< 375 . These inputs are considered inactive if the voltage to ground is 11-33 VDC.
4.10.2.2 King Serial DME Tuning
Pin Name Connector Pin I/O
NAV SER DME - DATA P4006 19 Out
NAV SER DME - CLOCK P4006 18 Out
SER DME
– CHAN REQ/PAR DME - 4MHZ
P4006 20 In*
SER DME
– RNAV MODE/PAR DME – 2MHZ
P4006 21 In*
NAV DME COMMON P4006 22 In
* These pins are inputs when the GNS 430W is configured for King Serial DME tuning
When NAV SER DME – DATA or NAV SER DME – CLOCK is asserted high and driving a 360
load, the driver output voltage is not less than 8 V, and when asserted low shall not be greater than 10
mV.
SER DME – CHAN REQ/PAR DME – 4MHZ, SER DME – RNAV MODE/PAR DME – 2MHz, and
NAV DME COMMON are considered active if either the voltage to ground is < 1.9 V or the resistance
to ground is< 375 . These inputs are considered inactive if the voltage to ground is 11-33 VDC.
NAV DME COMMON must be pulled low to indicate to the NAV module that it is the device
channeling the DME.