Garmin GPS 400W, Руководство по установке

Страница: 97 / 212

GNS 400W Series Installation Manual Page 5-19
190-00356-08 Rev. G
5.3.13 VOR DISCRETE INPUTS Page (GNS 430W
Only)
Select the VOR DISCRETE INPUTS Page (see Figure 5-18).
This page allows you to verify the operation of an external
VLOC transfer switch that may be present in the installation.
Selection Verify That:
REMOTE XFR
The box is filled in while a remote VLOC transfer switch is pressed.
5.3.14 VOR/LOC/GS CDI Page (GNS 430W Only)
Select the VOR/LOC/GS CDI Page (see Figure 5-19).
This page allows you to verify and calibrate the CDI outputs,
both lateral (
LAT ) and vertical ( VERT ) from the
VOR/LOC/Glideslope receiver, as well as the OBS resolver
input to the VOR receiver. It also allows you to select the format
for DME tuning data. Using the controls on the GNS 430W
front panel, make the selections below and verify the interfaces
as appropriate:
NOTE
The LAT, VERT, and SELECTED COURSE configurations only apply to installations
where a CDI/HSI is connected to the VOR/LOC/GLIDESLOPE pins on connector P4006.
CDI (LAT/VERT)
Selection Verify That:
Max left
The CDI is “pegged” to the left/up.
Full left
The CDI is deflected full scale to the left/up.
Std. left
The CDI is deflected left of center.
Center
The CDI is centered.
Std. right
The CDI is deflected right of center.
Full right
The CDI is deflected full scale to the right/down.
Max right
The CDI is “pegged” to the right/down.
FLAG (LAT/VERT)
Selection Verify That:
Hide
The LAT/VERT flag is hidden.
View
The LAT/VERT flag is in view.
S-FLG (LAT/VERT)
Selection Verify That:
Hide
The LAT/VERT superflag is hidden.
View
The LAT/VERT superflag is in view.
Figure 5-18. VOR DISCRETE
INPUTS Page
Figure 5-19. VOR/LOC/GS CDI Page