Garmin GPS 400W, Руководство по установке

Страница: 62 / 212

Page 4-8 GNS 400W Series Installation Manual
Rev. G 190-00356-08
4.4.2.4 Superflags
Pin Name Connector Pin I/O
MAIN LATERAL SUPERFLAG P4001 17 Out
MAIN VERTICAL SUPERFLAG P4001 18 Out
The output supplies not less than 500 mA on a 28 volt system and 250 mA on a 14 volt system with the
output voltage not less than (AIRCRAFT POWER –1.5 VDC) when the flag is to be OUT OF VIEW.
The output voltage with respect to ground is less than 0.25 VDC when the flag is to be IN VIEW.
NOTE
The super flag outputs are internally fused. Connections to equipment that exceeds the
specified current must be avoided, or return to the factory or an authorized service center
may be required for repair.
Pin Name Connector Pin I/O
MAIN OBS ROTOR C P4001 31 Out
MAIN OBS ROTOR H (GROUND) P4001 32 Out
MAIN OBS STATOR D P4001 33 In
MAIN OBS STATOR E (2.5V COMMON OBS) P4001 34 Out
MAIN OBS STATOR F P4001 35 In
MAIN OBS STATOR G (2.5V COMMON OBS) P4001 36 Out
MAIN OBS ROTOR C and H are a buffered output that is intended to drive the OBS rotors. MAIN OBS
STATOR D and MAIN OBS STATOR F are each phase and amplitude shifted version of the MAIN
ROTOR C output. Each pair is intended to read one of the two windings of the indicator‘s OBS stator.
4.4.3 Main Indicator Configuration
None.
4.4.4 Main Indicator Calibration and Checkout
Refer to Section 5.3.11 for the main CDI/OBS checkout.
4.4.5 Main Indicator Interconnect
Refer to Appendix H for the navigation indicator interconnect information.